Overview:
MSA311 is an ultra-small, low-cost three-axis accelerometer. It's cheap, but contains almost every "extra" you could want in an accelerometer: Triaxial sensing, 14-bit resolution 士 29 / 士 49 / 士 89 / 士 169 Optional scaling 12C interface on fixed 12C address 0x62 interrupt output multiple data rate options IHz to 500Hz current consumption as low as 2 port A in low power mode (chip itself only, Any supporting circuits) Click, double click, orientation, and free-fall detection MSA3 11 is very similar to MSA301 but is not a direct substitute. Address changed from 0x26 to T0x62! Does not include IZC where the sensor passes! ZC or SPI communicate (our library code supports both), so you can communicate with the same! It is shared by many other sensors on the ZC bus. There is an address selection pin, so you can have both accelerometers share a 12C bus.
In order to get you started quickly, we introduce. Make them easy to interact with. Both sides of the STEMMA OT contour OT connector with SPAR recognized "UN OW 11 C 1 Zc connector compatible between the hair plate and MSA311 for welding connection kind of other sensors and accessories. This allows you to use compatible cables in your open, or with each OT cable not included, but we have a variety in store of course, we have split all pins into standard connectors and added voltage regulator and level conversion so you can use them for 3.3V or SV systems respectively, For example Raspberry Pi + Feather series compatible or A R D U 1 No Unoo comes with A little 0. 1 "standard connector in case you want to use it with breadboard or punch board for easy installation with four mounting holes.
